(pack) Piston-Rod Sealing U-ring K36 NBR ID 4,76mm-36mm (choose Dimensions)

• Popularity - 4427 views, 632.4 views per day, 7 days on eBay. Super high amount of views. 17 sold.
• Price - Avg: $0.00, Low: $0.00, High: $0.00. Best quality when compared to PicClick similar items.
• Seller - + items sold. 0% negative feedback. Great seller with very good positive feedback and over 50 ratings.

K36 is a single acting piston - rod seal which consists of reinforced cotton fabric and nitrile rubber vulcanized together forming an integral sealing element.<br>PRODUCT ADVANTAGES<br>• Functions even with poor surfaces<br>• Reinforced cotton fabric base prevents the seal from extrusion<br>• Both rod and piston application<br>• Good sealing at low pressures<br>APPLICATION<br>Low to medium duty hydraulic cylinders , mobile hydraulics and presses.<br>MATERIAL<br>CODE<br>NBR<br>80 SHORE A<br>NB<br>8801<br>COTTON FABRIC NBR<br>NB<br>8004<br>OPERATING CONDITIONS<br>MEDIA<br>Mineral oils (DIN 51524)<br>HFA ve HFB<br>HFC<br>TEMPERATURE<br>-30°C +105°C<br>+5°C +60°C<br>-30°C +60°C<br>PRESSURE<br>≤250 Bar<br>≤250 Bar<br>≤250 Bar<br>SPEED<br>≤0.5 m/sn<br>≤0.5 m/sn<br>≤0.5 m/sn<br>Note: The above data are maximum values and cannot be used at the same time.<br>SURFACE ROUGHNESS<br>Ra<br>Rmax<br>Sliding Surface ØD-Ød<br>≤0.4 μm<br>≤3.2 μm<br>Groove Base Ødp - ØDb<br>≤1.8 μm<br>≤6.3 μm<br>Groove Flanks B<br>≤3.2 μm<br>≤16 μm<br>Note: It is recommended to have 50% to 90% of the working surface material contact area value.<br>INSTALLATION<br>K36 is to be assembled into open grooves. It is very important that the assembly tools must be of soft material and have no sharp edges. Before installation the sealing element must be oiled with system oil.<br>NOTES<br>The permissible sealing gap values of K36 piston - rod seal is given in the below table.<br>PERMISSIBLE SEALING GAP<br>Pressure(Bar)<br>S (mm)<br>150<br>0.2<br>250<br>0.1<br>Note: The largest sealing gap value occurring on the non-pressurized side of the seal does have a vital importance for the function of the seal and in this respect it is quite important to use the S value lower than the above indicated numbers.<br>